Logisim Simulator(Version 2.7.1)

-


Introduction of Logisim Simulator

Logisim is an educational tool for designing and simulating digital logic circuits.
it has simple toolbar interface and simulation so everyone can understand.

 
















Parts of Logisim Simulator





How to create a Circuit

Adding Gates
Adding Wires
Label






Simulating the Circuit

To use the circuit simulation, make sure to click the simulation icon  Once the hand tool is selected, use it to click on any input to change its logic state, and observe the effects of different inputs on the circuit outputs.







Analyze Circuit

we can analyze circuit in the logisim.























Comments

Post a Comment

Popular posts from this blog

Frequency Divider

-
Image
  Frequency Divider It called as Clock divider That circuit  takes an input signal of a  frequency  and generates an output signal of a frequency Frequency  is the number of occurrences of a repeating event per  unit of time Create Frequency divider using JK Flip Flops  A frequency divider can be constructed from J-K flip-flops by taking the output of one cell to the clock input of the next. The J and K inputs of each flip-flop are set to 1 to produce a toggle at each cycle of the clock input. For each two toggles of the first cell, a toggle is produced in the second cell, so its output is at half the frequency of the first. The output of the fourth cell is 1/16 the clock frequency. The same device is useful as a binary counte r Create & Simulate        
Read more

Demultiplexers

-
Image
De-multiplexer The de-multiplexer is a combinational logic circuit designed to switch one common input line to one of several separate output line. 1 to 4 De-multiplexers
Read more

Multiplexers

-
Image
  Multiplexer (MUX)   MUX is a Combinational Logic Circuit with more than one input line, one output line and more than one select line  It accepts the binary information from several input lines or sources and depending on the set of select lines, a particular input line is routed onto a single output line.  Multiplexer acts as a multiple-input and single-output switch It has only one output and   2n  inputs It identified as digital Switch Types of Multiplexers 1) 2 X 1 MUX                          2) 4 X 1 MUX        3) 8 X 1 MUX     1)    2 X 1 MUX    A 2-to-1 multiplexer consists of two inputs D0 and D1, one select input S and one output Y.  Depending on the select signal, the output is connected to either of the inputs. Since there are two input signals, only two ways are possible to connect the inputs to the outputs, s...
Read more