Multiplier

-
Multiplier
   
2 bit Multiplier

A Binary Multiplier is a digital circuit used in digital electronics to multiply two binary numbers and provide the result as output. The method used to multiply two binary numbers is similar to the method taught to school children for multiplying decimal numbers which is based on calculating partial product, shifting them and adding them together. Similar approach is used to multiply two binary numbers. Long multiplicand is multiplied by 0 or 1 which is much easier than decimal multiplication as product by 0 or 1 is 0 or same number respectively. Figure 1 below shows the block diagram of a 2-bit binary multiplier. The two numbers A1A0 and B1B0 are multiplied together to produce a 4-bit output P3P2P1P0.  






 

Comments

Post a Comment

Popular posts from this blog

Frequency Divider

-
Image
  Frequency Divider It called as Clock divider That circuit  takes an input signal of a  frequency  and generates an output signal of a frequency Frequency  is the number of occurrences of a repeating event per  unit of time Create Frequency divider using JK Flip Flops  A frequency divider can be constructed from J-K flip-flops by taking the output of one cell to the clock input of the next. The J and K inputs of each flip-flop are set to 1 to produce a toggle at each cycle of the clock input. For each two toggles of the first cell, a toggle is produced in the second cell, so its output is at half the frequency of the first. The output of the fourth cell is 1/16 the clock frequency. The same device is useful as a binary counte r Create & Simulate        
Read more

Multiplexers

-
Image
  Multiplexer (MUX)   MUX is a Combinational Logic Circuit with more than one input line, one output line and more than one select line  It accepts the binary information from several input lines or sources and depending on the set of select lines, a particular input line is routed onto a single output line.  Multiplexer acts as a multiple-input and single-output switch It has only one output and   2n  inputs It identified as digital Switch Types of Multiplexers 1) 2 X 1 MUX                          2) 4 X 1 MUX        3) 8 X 1 MUX     1)    2 X 1 MUX    A 2-to-1 multiplexer consists of two inputs D0 and D1, one select input S and one output Y.  Depending on the select signal, the output is connected to either of the inputs. Since there are two input signals, only two ways are possible to connect the inputs to the outputs, so one select is needed to do these operations. If the select line is low, then the output will be switched to D0 input, whereas if select line is high, then the out
Read more

Demultiplexers

-
Image
De-multiplexer The de-multiplexer is a combinational logic circuit designed to switch one common input line to one of several separate output line. 1 to 4 De-multiplexers
Read more